Vengeance HLR

Just in is the Vengeance HLR from X-Fusion.

There plenty of photos around but I thought since these are really the first full production models available to us I would share some more.
36mm stanchions
20mm thru axle
Rebound knob is the red one at top of the right leg, left side is the air cap.







In this shot you can see the compression tuning knobs. The small blue knob is for low speed and the larger gold knob is high speed compression. Each makes a noticeable change right thru the range.









Showing the back of the arch. Post type disc brake mounts.

Also the compression knob cover is in place in this shot

While these are 160mm travel they will work at any travel setting down to 100mm and have even been run at 80mm.

Comments

Post a Comment

Popular posts from this blog

SR Suntour Edge shock stuck down

Image
 The SR Suntour Edge shocks are popping up on a number of bikes these days and they seem like quite a nice little shock. We have heard of and seen a number on Focus Thron e-bikes that have been "stuck-down" This is where the main chamber pressure ends up in the negative chamber and causes the shock to collapse on itself. There are plenty of references out there on how to release a stuck down shock (I generally stick a rag through the eyelet to stop the can flying off) But the main issue is the cause of the air leak and how to fix it. With the ones we have seen it is the same cause each time and that is a sharp edge on the transfer port in the air can. As the main seal passes this port it get cuts, and over time this is enough to allow air from the main chamber into the negative. You can see the transfer port in the image above. If you run your finger over the port you'll be able to feel if there are any sharp edges. In this you can see the cut on the main seal where in th...
Read more

The new shock bushing tool

Image
We finally have our shock bushing tool made as we want it. The previous tools worked fine but being the finicky type I am it wasn't 'exactly' as good as I thought it should be. Not saying this one is perfect but in many little ways it is a much better tool. A lot of the credit for the finished product goes to Mick Warren at Macquarie Precision Engineering who turning my thoughts into reality. Given my skills in design and drafting (none at all) Mick had the job of turning all ideas expressed into this tool. The final product looks great and is helped by the cool anodising but most of what I am happy out is the precision of the parts. As a backgrounder: The shock eye bushings (aka DU bush) used in mtb shocks is designed to be sacrificial, but unfortunately it is also one of the smallest and best hidden parts AND really hard to change without setting aside some shed time. I know this because I did a few of these the hard way before I found the CTS bushing tool which...
Read more